Oracle StorageTek T10000 User Manual

View or Change TCP/IP Settings
4-20 StorageTek T10000 Tape Drive Operator's Guide
Gateway Lo Submenu
Note: Manufacturing ships drives with static Gateway Lo set to
either 000.000 .or 255.255
Operator panel window shows GWlccc.ddd .
Valid entries are 000-255 for each digit trio.
Defaults to the last saved selection.
Procedure:
1. Do one of the following actions:
a. Press Menu to bypass.
b. Press Select to start the change mode.
2. For each digit:
a. Press Select to increment the flashing digit until the desired value appears.
b. Press Menu to set.
If you attempt to enter a value greater than 255 in either trio, all digits flash when
the last digit is set.
3. Press Menu to advance to the next submenu; or, press Select to restart the change
mode.
Note: If all digits flash, press either Select or Menu to clear; then,
press Select to restart the change more.
Save TCP/IP Submenu
Operator panel window shows Save/IPL ?
This submenu is present if either the DHCP selection or the static TCP/IP settings
were changed.
Saving TCP appears for 2 seconds after you press Select.
After saving the TCP configuration, the drive automatically perform an IPL.
Save Fails appears for RAM problems.
Procedure:
■ Do one of the following actions:
– Press Menu (No) to cancel changes.
– Press Select (Yes) to save changes and initiate an IPL.
Exit TCP/IP Submenu
Operator panel window shows Exit TCP ?
This submenu offers you the option to either repeat the TCP/IP submenus or advance
to the next menu.
Procedure:

Oracle StorageTek T10000 Specifications

General

Brand	Oracle
Model	StorageTek T10000
Category	Storage
Language	English