Oracle StorageTek T10000 User Manual

Messages
D-2 StorageTek T10000 Tape Drive Operator’s Guide
CodUpFail3 The tape drive cannot read code from the data
cartridge tape.
Retry the operation, or try another cartridge tape. If
the problem persists, contact authorized service
personnel.
CodUpFail4 The data cartridge tape is not a code update
cartridge tape.
Try another code update cartridge tape.
If the problem persists, contact authorized service
personnel.
DatCrFail1 The tape drive cannot create (reformat or
reclaim) a cartridge tape.
Ensure that the data cartridge tape is write-enabled,
or try to reformat the tape on another drive. If the
problem persists, contact authorized service
personnel.
DmpCrFail1 The tape drive cannot create (reformat or
reclaim) a diagnostic dump tape.
Ensure that the data cartridge tape is write-enabled.
If the problem persists, contact authorized service
personnel.
DmpCrFail2 The tape drive cannot read the format of the
data cartridge tape.
Retry the operation, or try another cartridge tape. If
the problem persists, contact authorized service
personnel.
DmpWrFail1 The tape drive cannot write diagnostic data
onto the data cartridge tape, or the tape drive
cannot position the data cartridge tape.
Contact authorized service personnel.
DmpWrFail2 There is no diagnostic dump data to process. Contact authorized service personnel.
xxxx :Dmp y Alternates with *(an asterisk) after completion
of IPL, where xxxx = the FSC of last dump data
collected and Y = number of uncollected dumps
in non-volatile memory.
Contact authorized service personnel who accesses
the diagnostic data and collects it to tape or to the
host.
DumpAgain ? alternating
with Chk xxxx, xxxx is
an FSC. The Service
indicator is flashing.
The tape drive detected the same error within a
minute.
IPL the tape drive. If the problem persists, contact
authorized service personnel.
DumpToHost The dump or event log is being transferred to
the host; operator panel switches are locked.
None
Exp ClCart The cleaning cartridge is used up. Replace the cleaning cartridge.
Fix CfgErr The checksum does not match after an IPL. Contact authorized service personnel.
Init xxxx. xxxx is an
FSC
An initialization error occurred. Contact authorized service personnel.
IPL Pend The IPL switch has been pressed. None
Load CC The common controller code is loading; IPL is
proceeding.
None
Loading A cartridge tape is loading. None
Load xxxx , xxxx is an
FSC
The load or unload operation failed. If the load failed, insert another cartridge tape. If it
loads successfully, suspect the original tape. If
another tape fails to load, IPL the tape drive.
If the problem persists, contact authorized service
personnel.
Load FIBRE Fibre Channel firmware is loading; IPL is
proceeding.
None
Locating The tape drive is doing a high-speed seek. None
Memory Err The IPL failed. Perform the tape drive IPL again. If the problem
persists, contact authorized service personnel.
NTReady F A write-protected tape is in the process of a
manual unload.
None
NTReady U A write-enabled tape is in the process of a
manual unload.
None
Offline alternating
with *
The tape drive is offline. None
Table D–1 (Cont.) Operator Panel Display Messages
Display Meaning Recommended Action

Oracle StorageTek T10000 Specifications

General

Brand	Oracle
Model	StorageTek T10000
Category	Storage
Language	English