Philips DVDR600VR User Manual

E9480UD_EN.qx3 04.7.22 8:26 PM Page 30 <}
30 Clock Setting
Time/Date Automatic
The Recorder can set the time and date automatically by referring to a PBS
station. If the Recorder chooses an incorrect PBS channel or sets the
time/date incorrectly, set the clock manually, See page 31.
Before you begin, make sure TV channels are set. See page 28.
_* Make sure the Recorder is in DVD mode, Press DVD so the DVD light
appears on the front of the Recorde_
Press SYSTEM MENU. Press _1 to select 1"[' in the top left
corner of the menu bar at the top of the TV screen,
Press • repeatedly to select oT" at the end of the secondmenu screen, then press I_ to enter the Installation menu,
Press • repeatedly to selectTimelDate, then press I1_.
Automatic will be selected. Press I_,
With PBS Channel selected, press _1 or I1_ to choose the
channel number of your PBS station, then press OK.
Ifyou do not know your PBS channel numbeu choose Auto, The
Recorder will choose a PBS station for you and set the time,
If you want to set the clock manually, choose Off.The Recorder will
not update the time automatically according to a PBS station.
Time/date
Automatic
V PBSGha_ael • 010 •
• Da_igbtSa_ng Off
TimeZone Auto
T0stem
Press OK
Press • to choose Daylight Saving. Press _1 or I_ to choose
On, Off, or Auto, then press OK. Choose Auto ifyou want the
clock set according to the PBS station's Daylight Savings Time schedule.
Time,date
Automatic
• PBSOha_ael 010
• TmeZone ,_uto
Tostore
PressOK
PHILIPS
Press • to chooseTime Zone. Press _1 or I_ repeatedly to
choose your time zone, then press OK.
If you want the Recorder to use the time zone fi'om which your PBS
station broadcasts, choose Auto, But, if your PBS station broadcasts
fi'om a different time zone than the one in which you live, be sure to
select your time zone instead.
Time/date
Automatic
PBSOhaaael 010
• DaylightSa_ng Off
I" TimeZone •,_uto •I
T0stem
PressOK
Press SYSTEM MENU repeatedly to remove the menus. Press
STANDBY-ON O to turn offthe Recorder. In a few minutes, the
time will appear on the display panel on the fi'ont of the Recorde_:
If the Recorder cannot find the time, you may see an error message
when you turn on the Recorde_: Check the PBS channel and try again.
On set the clock manually. See page 31.
Helpful Hints
The Recorder may set the clock
when you complete Initial
Setup. If the correct time
appears an the display, you do
not need to reset the clock.
The factory default setting of
Daylight Saving is On.
The Recorder can use the PBS
channel to set the clock only if
the Pt_Schannel is a memo-
rized channel.To set up chan-
nels, see page 28.

Philips DVDR600VR Specifications

Operating Environment

temperature range (operation)	0°C to 40°C

Power

standby power consumption	< 3 W
power supply	90.140 V AC (120 V nom), 50/60 Hz

Sound

signal/noise ratio	95
distortion and noise (1kHz)	85 dB
dynamic range (1kHz)	85 dB
D/A converter	24 bit, 96 kHz
crosstalk (1kHz)	95 dB

Video Recording

tape speeds	LP, SP
recording system	NTSC
recording modes	M1: 60 minutes, M2: 120 minutes, M2x: 150 minutes, M3: 180 minutes, M4: 240 minutes, M6: 360 minutes
max recording time on DVD	6 hr

Audio Playback

MP3 bit rates	32 - 320 kbps
compression format	Dolby Digital, PCM, MPEG2 Multichannel, MP3, DTS

Picture/Display

D/A converter	10 bit, 54 MHz

Weight and Dimensions

packaging dimensions	542 x 181 x 375 mm
product dimensions	435 x 100 x 262 mm