E9480UD_EN.qx3 04.7.22 8:26 PM Page 64 <)
64 Digital Output
After connecting the Recorder to yourTV and other equipment, you may
need to change the Recorder's Digital Output setting. Look to see which
Recorder audio jacks you connected to your other equipment, then set
Digital Output accordingly.The information in step 4 will help you decide.
Adjust Digital Output only if you used the Recorder's COAXIAL DIGITAL
AUDIO OUT jack. See page 16. (If you used the white/red AUDIO OUT
L!R jacks, set Digital Output to Off. See page 65 to adjust the sound at
Analog Output.)
® Before you begin, make sure the Recorder is in DVD mode. Press DVD so
the DVD light appears on the front of the Recorden
Press SYSTEM MENU. Press _1 to select T_, in the top left
corner of the menu bar at the top of the TV screen.
Press • repeatedly to select '(] , then press I_.
3
Digital output will be selected. Press I1,,-.
Press • or• to select Off, PCM only, or All, then press OK.
® Select Off if you did not use the COAXIAL DIGITAL AUDIO
OUT jack.
_* Select PCM only if you used the Recorder's COAXIAL DIGITAL
AUDIO OUT jack for connections, but your Stereo does not
include a built-in digital multi-channel decode_ PCM represents Pulse
Code Modulation.
® Select All if you connected the Recorder's COAXIAL DIGITAL
AUDIO OUT jack to a Stereo that has a built-in multi-channel
decoder. See page 16.
[ [_ [ Sound
[ ,(_ ii Digilaleulpul _ O_f-
[ _ ii [Nig_itlnode A
To Next Page
Loading...
Need help?
Operating Environment
Power
Weight and Dimensions
