12.16
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
TRANSMISSION / GEAR POSITION
SWITCH
The transmission (gear position) switch
q
is located on
the RH side of the transmission and can be accessed
through the rear RH wheel well area.
TESTING
1. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do
not pull on the wiring.
2. Test the transmission switch continuity readings for
each gear position and compare to the specification
table below.
GEAR
POSITION
RESISTANCE VALUE
WHEN MEASURED AT SWITCH
TERMINALS A AND B
HIGH 620 Ω
LOW 300 Ω
NEU
160 Ω
REV 75 Ω
PARK 24 Ω
BRAKE PRESSURE SWITCH
The brake pressure switch
q
is located on the rear brake
line outlet on the master cylinder.
TORQUE
Brake Pressure Switch:
15 ft-lbs (20 Nm)
NOTICE
Always replace brake system seals if fastener is
loosened or removed.
1. Disconnect the wire harness from the brake switch.
2. Connect an ohmmeter across switch contacts.
Reading should be infinite (OL).
3. Apply foot brake and check for continuity between
switch contacts. If there is no continuity or greater
than 0.5 Ω resistance when the brake is applied with
slight pressure, first clean the switch contacts and re-
test. Replace switch if necessary.
ELECTRICAL
To Next Page
Loading...
Need help?
General
