Installing SoundStructure Devices
8 - 29
Once entries have been moved, select “Save Selected” to save the new execu-
tion order.
Running Presets
Both full and partial presets may be executed when in SoundStructure Studio
by left clicking the preset to execute and then clicking Run Preset.
A control system would execute the preset with the command action run as in
the following example:
run “Power-On”
In version 1.5 or later firmware, once a preset run command has been exe-
cuted, the SoundStructure system will immediately respond with an
acknowledgment as shown below to indicate that it is running a preset.
run “Power-On”
Full Presets
When a full preset is executed all the outputs of the system are muted during
the execution of the preset and then unmuted after the full preset finishes
executing.
No command acknowledgements are generated when a full preset is executed.
If there are parameters that a control system needs to know the value of, these
parameters should be queried after the execution of the preset.
Once the full preset has finished running, a ‘ran’ command acknowledgment
is generated as shown next.
To Next Page
Loading...
Need help?
General
