Polycom SoundStructure C16 User Manual

Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12
3 - 20
Logic Outputs
All logic outputs are configured as open-collector circuits and may be used
with external positive voltage sources. The maximum voltage that should be
used with the logic outputs is 60 V. Each pin may sink up to 60mA. When
using the internal 5V power supply, the maximum current that may supplied
across all logic outputs on a SoundStructure device is 500 mA.
The open collector design is shown in the following figure and works as a
switch as follows: when the logic output pin is set high (on), the transistor will
turn on and the signal connected to the logic output pin will be grounded and
current will flow from the logic output pin to chassis ground.
When the logic output is set low (off), the transistor will turn off and an open
circuit will be created between the logic output and the chassis ground pre-
venting any flow of current as shown in the following figure.
Examples of using logic input and output pins may be found in Chapter 9 of
this manual.
Control Virtual Channels
The concept of virtual channels also applies to the logic inputs and outputs.
The A/V designer can create control virtual channels that consist of a logic
input or output pin.
Logic
Controller
SoundStructure Logic Output
Logic Output Pin
Chassis
Ground
Logic Output = 0
Low (Off)
Logic Output = 1
High (On)
Chassis GroundChassis Ground
Logic Output PinLogic Output Pin

Polycom SoundStructure C16 Specifications

General

Brand	Polycom
Model	SoundStructure C16
Category	Conference System
Language	English