Command Protocol Reference Guide
A - 111
Description
This parameter sets the ratio of the target gain applied by the limiter versus the
difference between the limiter threshold and the input signal level. For exam-
ple, if the limiter ratio is 10 (i.e., 10:1) and the input signal level is 6 dB above
the limiter threshold, the limiter applies -5.4 dB of gain.
dp_lim_thresh
Limiter Threshold
Phys Chans
Conferencing Mic/Line Input, Conferencing Line Output,
Sound Reinforcement Mic/Line Input, Sound Reinforcement
Line Output, Analog Telephony Input, Analog Telephony
Output, Submix, ConferenceLink Aux Input, ConferenceLink
Aux Output
Virt Chans Mono, Stereo
System Limits Minimum: 1.0, Maximum: 100.0, Resolution: 0.1
Default 10.0
User Limits
Supported
No
Event Source No
Argument Argument value
Argument Argument value
Channel Type Virtual Channel
Value Type Floating-Point
Read/Write Mode Read/Write
Phys Chans
Conferencing Mic/Line Input, Conferencing Line Output,
Sound Reinforcement Mic/Line Input, Sound Reinforcement
Line Output, Analog Telephony Input, Analog Telephony
Output, Submix, ConferenceLink Aux Input, ConferenceLink
Aux Output
Virt Chans Mono, Stereo
System Limits Minimum: -100.0, Maximum: 0.0, Resolution: 0.1
Default 0.0
User Limits
Supported
No
Event Source No