47
◦
Confirm:
Once you have manually entered the Ar-Q values, select the Confirm button and press the encoder to apply the settings.
◦
Splays:
When you manually select the Box Count, Box Number, and Total Splay, you will see the correct splay angle for your
array listed in the Splays window. The angles read left to right are the angles of the loudspeakers in the array from top to bottom.
Settings
This menu contains important, but less frequently viewed, loudspeaker parameters.
•
Security:
A 4-digit code can be entered to lock the loudspeaker settings from being adjusted, until the code is re-entered. After a
code has been entered and the loudspeaker is locked, the user interface will return to the Home Screen, and a lock icon will be
displayed in the upper left-hand corner.
•
Sensitivity:
Determines the signal level needed to drive the loudspeaker to maximum output.
◦
+24 dBu:
For use with high-output, professional mixing consoles (using typically XLR connectors).
◦
+4 dBu:
For use with low-output mixing consoles or audio interfaces (using typically 6.35 mm [1/4-in] TRS or RCA connectors)
•
LED Mode:
Front and Rear lit, Front only, Rear only, Blackout (all out).
•
LCD Brightness:
Adjusts LCD screen brightness for light or dark environments.
•
Network:
Displays network IP address and subnet for QSC SysNav connection, as well as IP address, subnet, and TX Source for the
Dante
®
network connection. DHCP or static IP address can also be selected.
Utilities
•
Diagnostic Test:
An isolated tone is played separately through the low frequency and high frequency drivers to validate if it is
functioning. If no tone is heard through either driver, contact a local QSC Service Center for assistance.
•
Factory Reset:
Returns all loudspeaker settings to factory default state.
•
Re-calibrate Angle:
On rare occasions (after service, accidental shock, etc.), the internal accelerometer may need to be re-
calibrated. Place the loudspeaker on a known, level surface and run this re-calibration process. It is best to re-calibrate all
loudspeakers on the same surface for consistency.
NOTE: When re-calibrating the accelerometer, make sure no audio is connected or playing through the loudspeaker.
•
Regulatory:
Statements for regional regulatory compliance.
Additional Functions
•
ID Button:
When connected to System navigator, the ID button can be pressed to locate the speaker in the design. The resulting
speaker will flash in the design for 30 seconds or until the ID button is pressed again.
•
Factory Reset Shortcut:
With the loudspeaker powered on, press and hold the MENU and ID buttons simultaneously for 3 seconds
to initiate a factory reset.
To Next Page
Loading...
Need help?
General
