RCA ColorTrak 2000 User Manual

You're ready to enjoy this new
dimension in television with your new
stereo TV. Your TV is fully capable
of reproducing stereo sound from TV
stations transmitting stereo sound in
your area. All you have to do to enjoy
stereo sound is make sure the TV's
"AUDIO: STEREO/MONO"
function is set to "STEREO" so the
"IV can receive stereo broadcasts.
Normally this function can be left in
the "STEREO" mode. Your 'IN will
then automatically reproduce either
stereo or monaural sound-whatever is
broadcast.
In some fringe viewing areas, however,
the stereo signal may not be strong
enough for quality reception. The
signal may drift or the reproduction
may become noisy. Should that occur,
change the "AUDIO: STEREO/
MONO" function to the "MONO"
mode to receive clearer, cleaner
sound.
AUDIO
Button
Resetting the "AUDIO: STEREO/MONO"
Function to Receive Stereo
--(with or _thout remote control)
1. Press AUDIO button repeatedly until
"-" and "+" marks move down to
"AUDIO: MONO/STEREO".
I REBLE
BASS
BALANCE
- AUDIO: STEREO
SAP: OFF
SPEAKERS: ON
2. Press either " -" or "+ '"to change
"AUDIO:" from "MONO" to
"STEREO".
Note: Each time you press the "-" or
"+" button, "'AUDIO:" will change
from "MONO" to "STEREO" or
"STEREO" to "MONO".
TREBLE
BASS
_ BALANCE
- AUDIO: MONO
SAP: OFF
SPEAKERS: ON
[:ji!:iii,:_
iiiiiiiiii_ii!iii!!i_
?]i !?ii:ii
t
r 5S?" _:I
I
:I
:r [] ::r : :_ : r : iN::_£, : _}::?':'_:::t
rr 2 : 2: ] [:]):: 1[ [_)i:::_
_:r_NN:,"
I
16

RCA ColorTrak 2000 Specifications

General

Brand	RCA
Model	ColorTrak 2000
Category	TV
Language	English