Playing DVDs
28 Chapter 2
Repeating Specific Sections of a Disc
You can repeat a section of a DVD or CD by first marking the starting point and
the end point:
1. During playback, press the REPEAT button.
2. Use the left and right arrows to select A-B. The A will flash, indicating that
you should set the starting point.
3. Press the SETUP/ENTER button at the beginning of the section you want to
repeat. This will be point A. The B will now flash, indicating that you
should set the end point.
4. Press the SETUP/ENTER button at the end of the section you want to
repeat. The minimum repeat time is five seconds.
5. The section will now begin repeating in a continuous loop.
To cancel the repeating section:
1. Press the REPEAT button to open the repeat menu.
2. Use the left and right arrows to highlight Off, then press SETUP/ENTER.
Marking Starting Points
You can access a specific place in a DVD by inserting up to three
bookmarks:
1. During playback, press the MARK button on the remote.
2. Use the left and right arrows to move to one of the three bookmark
placeholders, which are indicated by dashes (“- - -”).
3. Find the place you want to bookmark, then press SETUP/ENTER. The
placeholder will change to a number.
4. Repeat steps 2-3 for each bookmark you want to place.
5. When finished, press the MARK button to exit.
To find and play the place you marked:
1. During playback, press the MARK button on the remote.
2. Use the left and right arrows to move to the desired bookmark, labeled 1,
2, or 3.
3. Press PAUSE/PLAY to go to the bookmarked place on the disc.
To clear a bookmark:
1. During playback, press the MARK button on the remote.
2. Use the left and right arrows to move to the bookmark you want to clear,
labeled 1, 2, or 3.
3. The bookmark number will flash. Press CLEAR and the number changes to
a dash, indicating that the bookmark has been cleared.
Repeat Enter to Set
Off Chapter Title A-B
Mark Enter to Set
- - -
Mark Play or Clear
1 2 3
To Next Page
Loading...
Need help?
General
