Playing Videotapes
32 Chapter 3
To add the date and time stamp:
1. Press the SETUP/ENTER button on the remote.
2. Use the up and down arrow buttons to point to VCR & Channel Setup and
then press the right arrow button to select it.
3. Move the selection arrow to Date/Time Stamp then press the right arrow
button to select from the following options:
• Timer—Time and date will appear only on timer recordings.
• All—Time and date will appear on every recording.
• None—Time and date will not appear.
Recording Speeds
You can change the recording speed from SP (Standard Play) to SLP (Super
Long Play) to fit six hour of programming on a T-120 VHS tape. The selected
recording speed will appear on the front panel display.
To change the recording speed:
1. Start the recording.
2. Press the SP/SLP button on the remote:
• SP—Standard Play, for best quality.
• SLP—Super Long Play, for maximum recording time (three times as long
as SP).
Maximum Recording Time—SP versus SLP
Tape Length SP SLP
T-120 2 hrs 6 hrs
T-160 2 hrs 40 min 8 hrs
T-180 3 hrs 9 hrs
Recording the Date and Time
The date and time stamp allows you to overlay the date and time at the beginning of your
recordings.
VCR & CHANNEL SETUP
VCR Plus Setup
Channel Setup
Date/Time Stamp All
Auto Play/Rewind Both
Record Source Auto
Panel Display Bright
________________________
To Move To Select
GO BACK to Quit
To Next Page
Loading...
Need help?
General
