5. For "Driver Encryption Key", press [Change].
"Driver Encryption Key" is one of the extended security functions. For details about this and other
security functions, see "Specifying the Extended Security Functions".
6. Enter the driver encryption key, and then press [OK].
Enter the driver encryption key using up to 32 alphanumeric characters.
The network
administrator must give users the driver encryption key specified on the machine so they
can register it on their computers. Make sure to enter the same driver encryption key as that is specified
on the machine.
7. Press [OK].
8. Press the [User Tools/Counter] key.
For details about specifying the encryption key on the TWAIN driver, see the TWAIN driver Help.
• p.33 "Logging in Using Administrator Authentication"
• p.34 "Logging out Using Administrator Authentication"
•
p.221 "Specifying the Extended Security Functions"
Specifying an IPP Authentication Password
This can be specified by the network administrator.
Specify the IPP authentication passwords for the machine using Web Image Monitor.
You can enhance security to make IPP authentication passwords harder to break.
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
7. Enhanced Network Security
184
To Next Page
Loading...
Need help?
General
