because the response is slow during initial key exchange, it may take some time to confirm that
transmission has been established.
Specifying Encryption Key Manual Settings
This can be specified using Web Image Monitor.
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
The network administrator can log in.
Enter the login user name and login password.
4. Click [Configuration], and then click [IPsec] under "Security".
The IPsec settings page appears.
5. Select [Active] for "Encryption Key Manual Settings".
6. Click [Edit] under "Encryption Key Manual Settings".
7. Set items for encryption key manual settings in [Settings 1].
If you want to make multiple settings, select the settings number and add settings.
8. Click [OK].
9. Select [Active] for "IPsec" in "IPsec".
10. Set "Exclude HTTPS Communication" to [Active] if you do not want to use IPsec for HTTPS
communication.
11. Click [OK].
12. Click [OK].
13. Click [Logout].
telnet Setting Commands
You can use telnet to confirm IPsec settings and make setting changes. This section explains telnet commands
for IPsec. To log in as an administrator using telnet, the default login user name is "admin", and the password
is blank. For details about logging in to telnet and telnet operations, see "Using telnet", Network and System
Settings Reference.
Transmission Using IPsec
211
To Next Page
Loading...
Need help?
General
