5. Press the [Online] key.
The display returns to the initial screen.
• Duplex printing is not supported for the following paper types:
• Cardstock, Thick Paper 2, Thin Paper, Thick1: Dup.Back, Thick2: Dup.Back, Coated Paper
Loading Paper into the 2000-sheet Paper Feed Unit
This section describes how to load paper into the 2000-sheet paper feed unit (tray 3).
• Make sure paper is not stacked higher than the upper limit mark inside the paper tray. Paper misfeeds
might occur.
• Do not mix different types of paper in the same paper tray.
• During printing, do not open or close the printer covers, bypass tray, or paper tray.
• Make sure to align paper and push it neatly to both sides of the tray. If you do not, it can cause a
paper misfeed.
• The default paper size of the 2000-sheet paper feed unit is as follows:
• : A4
• : 8
1
/
2
× 11(Letter)
• The paper tray guides are fixed. However, you can switch the setting between A4 and 8
1
/
2
11
(Letter) . If you wish to use a paper size other than the default, contact your sales or service repre-
sentative.
1. Carefully pull out the paper tray until it stops.
When printing using the bypass tray, do not pull out the paper tray.
Loading Paper
105
To Next Page
Loading...
Need help?
General