Cleaning the Registration Roller
If types of paper other than the standard types are used, specks of paper may stick around the registration
roller, causing problems. Clean the registration roller if white dots appear on prints.
• The inside of this printer becomes very hot. Do not touch parts labeled "v" (indicating a hot surface).
Touching these parts will result in burns.
• Do not use chemical cleaners or organic solvents such as thinners or benzine.
• Do not touch the belt of the roller when cleaning.
1. Turn off the printer and unplug the power cable.
2. Push up the lever on the right side, and open the printer’s right cover carefully.
The registration roller is installed as shown below.
Cleaning the Registration Roller
155
To Next Page
Loading...
Need help?
General