Enhanced Security HDD Option Type M10 (D792-09)
SM 2-79 D255/D256/M281/M282
Installation
After Installing the HDD
1. Connect the power cord and turn ON the main power. A message prompts you to
format the hard disk.
2. Press [Format].
3. Wait for the machine to finish formatting the hard disk.
 Do not touch the power switch while the hard disk format is in progress. Wait for the
machine to tell you that the formatting is finished.
4. Turn the main power OFF/ON after a message tells you formatting is finished.
5. Enter the SP mode.
6. Execute SP5-853-001 to copy the preset stamp data from the firmware to the hard disk.
Follow the instructions on the screen. This will require three or four minutes.
7. Turn the main power OFF/ON.
⇒
Rev. 09/15/2016
To Next Page
Loading...
Need help?
General
