Paper Feed Unit PB1100 (D3C2-01, 02)
SM 2-23 D255/D256/M281/M282
2.4.2 INSTALLATION PROCEDURE
For instructions on unpacking and installing Paper Feed Unit PB1100, please refer to the
operating instructions "About This Machine" for MP 501/601, or "Operating Instructions" for SP
5300/5310.
When installing with the caster table
Installation by service representative may be required when installing Paper Feed Unit PB1100
with Caster Table Type M24, depending on the machine configuration.
Machine
Configuration
MP 501/601 SP 5300/5310
Printer only
With 1 to 4 PFU
PB1100
Printer only, or
with 1 PFU
PB1100
With 2 to 4 PFU
PB1100
Who can install
the caster table
End user
Service
representative
*1
End user
Service
representative
*1
*1 The attaching stands and connecting parts need to be installed to prevent the machine from
falling over. If it falls or topples over, an injury might occur. For instructions on installing Paper
Feed Unit PB1100 and Caster Table Type M24, please refer to the procedure described in this
section.
Installing the optional paper feed unit on the caster table
 Turn OFF the main power, and unplug the machine power cord before starting the
following procedure.
 You need two or more persons to lift the main machine. The main machine is highly
unstable when it is lifted by one person, and may cause injury or property damage.
 Be sure to hold the specified positions when lifting the machine.
1. Pull out the paper feed tray [A] of the optional paper feed unit.
2. Remove all tape and retainers.
To Next Page
Loading...
Need help?
General
