Service Program Mode
SM Appendix 3-3 D255/D256/M281/M282
No. Description
5 Press two times to leave the SP mode and return to the copy window to
resume normal operation.
6 Press any Class 1 number to open a list of Class 2 SP modes.
7 Press to scroll the show to the previous or next group.
8 Press to scroll to the previous or next display in segments the size of the
screen display (page).
9 Press to scroll the show the previous or next line (line by line).
10 Press to move the highlight on the left to the previous or next selection in
the list.
SP 5300/5310
Select one of the Service Program modes (Service, or Engine) with [
/ ] keys, and then
press the [OK] key.
Switching Between SP Mode and Copy Mode for Test Printing (MP 501/601
Only)
1. In the SP mode, select the test print. Then press [Copy Window].
2. Use the copy window (copier mode), to select the appropriate settings (paper size, etc.)
for the test print.
3. Press [Start] to start the test print.
4. Press SP Mode (highlighted) to return to the SP mode screen and repeat from step 1.
Selecting the Program Number (MP 501/601 Only)
Program numbers have two or three levels.
1. Refer to the Service Tables to find the SP that you want to adjust before you begin.
2. Press the Group number on the left side SP Mode window that contains the SP that you
want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to show the SP number
that you want to open. Then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item that you
want to set and press it. The small entry box on the right activates and shows the
below default or the current settings.
To Next Page
Loading...
Need help?
General
