Controller Options
151
• Administrator login password
If any of these settings is at a factory default value, tell the customer these settings must be changed before
you do the installation procedure.
3. Make sure that “Admin. Authentication” is ON.
[User Tools] > [Machine Features] > [System Settings] > [Administrator Tools] > [Administrator
Authentication Management] > [Admin. Authentication]
If this setting is OFF, tell the customer this setting must be ON before you do the installation procedure.
4. Make sure that “Administrator Tools” is enabled (selected).
[User Tools] > [Machine Features] > [System Settings] > [Administrator Tools] > [Administrator
Authentication Management] > [Available Settings]
If this setting is disabled (not selected), tell the customer this setting must be enabled (selected) before you
do the installation procedure.
Seal Check and Removal
• You must check the box seals to make sure that they are not removed after the items have been sealed
in the box at the factory before you do the installation.
1. Check the box seals [A] on each corner of the box.
• Make sure that a tape is attached to each corner.
• The surfaces of the tapes must be blank. If you see “VOID” on the tapes, do not install the
components in the box.
2. If the surfaces of the tapes do not show “VOID”, remove them from the corners of the box.
3. You can see the “VOID” marks [B] when you remove each seal. In this condition, they cannot be attached
to the box again.
To Next Page
Loading...
Need help?
General