12
Histogram Analysis
The histogram analysis function can provide the statistic view for waveform and
measurement results, enabling you to judge the trend of waveforms, and quickly
locate the potential problems of the signal. This series oscilloscope supports
histogram types including Horizontal, Vertical, and Measure. For the Measure
Histogram function, refer to
Histogram
of the "Measurements" chapter. This chapter
only introduces the Horizontal and Vertical histogram.
Click or tap the function navigation icon
and select Histogram to enter the
Histogram menu.
Figure 12.1 Histogram Menu
12.1 To Enable or Disable the Histogram Function
In Histogram menu, click or tap the Enable on/off switch to enable or disable the
histogram analysis. After the histogram function is enabled, with the on-going
acquisition and measurement of the waveforms, the height of the bar graph will
change within the set range of the histogram window to indicate the number of times
for data statistics.
Take horizontal histogram as an example. After the histogram function is enabled, the
histogram analysis view as shown in the figure below is displayed on the screen. Also,
the "Histogram" label appears on the
Result bar at the right side of the screen.
Histogram Analysis
DHO800 User Guide
154
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
To Next Page
Loading...
Need help?
General
