Optional Features
BASO-2 - 02.07 - V07 Page 7-7
7.1.5 Installing the refrigerator
7.1.5.1 First-time installation
Note:
The refrigerator must be installed and initialized by a licensed after sales service
agent
See also chapter 3.
7.1.5.2 Set temperature
You can regulate the refrigerator's temperature with the built-in temperature control. You
will find the temperature control when you lift the refrigerator’s panel. Please see the pic-
tures on the previous page.
1. To move the rotary knob on the tempera-
ture control lift the panel until it stops.
2.1 Warmer temperature:
Turn the rotary knob anti-clockwise.
2.2 Colder temperature:
Turn the rotary knob clockwise.
2.3 Placing the temperature control in the
normal position:
Turn the rotary knob anti-clockwise until it
stops and then clockwise until it reaches the
scale mark “A”.
Attention!
The refrigerator’s normal temperature setting depends on the ambient
temperature and will have to be adjusted either up or down.
2.4 Temperature “OFF”
Turn the rotary knob on the temperature control anti-clockwise
until it stops
3. Lower the panel.
Note:
• The refrigerator should be turned on at least one hour before use, so
that the cooling circuit (3 -5 °C) is ready for operation.
• Never put warm milk in the refrigerator, as it would take too long to
reach the 3 - 5 ° C temperature.
• Never put warm milk in the refrigerator. Coated with ice due to con-
densed water! (Regular defrosting necessary.)
Normal
position
Rotary knob
on the
temperature
control
Picture of temperature control
To Next Page
Loading...
Need help?
General
