Optional Features
BASO-2 - 02.07 - V07 Page 7-17
7.13 User instructions for special machines (water tank)
The following information only applies to machines with fresh and wastewater tanks.
7.13.1 Refill fresh water tank
When the level in fresh water tank is too low, the [
] key flashes. The following message
is displayed:
1. Take out the fresh water tank.
2. Fill up with fresh water.
3. Put the water tank back in place.
4. Quit by pressing the flashing red [
] key.
To prevent the water pump from functioning without water, no products can be served if
the water level is too low. The current product is served.
Always check the water level before running the cleaning program.
7.13.2 Empty wastewater tank
When the wastewater tank is full, the [
] key flashes. The following message is dis-
played:
1. Remove the wastewater tank.
2. Empty and, if necessary, rinse.
3. Put the wastewater tank back in place.
4. Quit by pressing the flashing red [
] key.
To prevent the wastewater tank from overflowing, no products can be served. If the mes-
sage is displayed while a product is being served, service continues.
Always empty the wastewater tank before running the cleaning program.
7.13.3 User instructions for machines with fresh and wastewater tanks (trolley-mounted)
Capacities are as follows:
Fresh water tank: 16 liters.
Wastewater tank: 11 liters
The fresh water tank must be filled daily with fresh, clean drinking water.
If the machine is out of use for lengthy periods, both tanks must be emptied and
cleaned.
Always keep the inside of the trolley dry.
Only place the tanks in the space provided (level monitoring).
The trolley must be pulled, not pushed, during transport (safety measure).
The trolley is not intended for transportation of merchandise. The manufacturer accepts
no liability for damage caused by misuse of the trolley or failure to respect the user in-
structions.
selection locked
watertank empty
selection locked
waste watertank full
To Next Page
Loading...
Need help?
General
