User Instructions
BASO-2 - 02.04 - V07 Page 4-5
4.4. Routine operation
4.4.1. Making the coffee machine ready for operation
1. Check the following points before switching on the coffee machine:
- That it is connected to the mains power supply
- That the water supply is turned on
- The coffee bean container is full
Danger!
DO NOT reach into the mill when refilling the coffee container(s) and DO NOT
press any of the product buttons when refilling!
- The grouts container is empty
- The (unlit) display shows the following message is displayed:
2. Press [ ] key Î All of the buttons light up briefly.
The following messages are displayed:
Once the operating temperature
has been attained:
For coffee machines with a fresh water tank, see chapter 5.5.
Depending on how the coffee machine is programmed, another message may be dis-
played when the coffee machine is ready for operation, especially if payment mode is
activated.
Note:
If the cleaning program was run before the coffee machine was switched off, a
rinse cycle is automatically run when the coffee machine is re-initialized and, if
programmed to do so, a sample coffee is served. (Place a cup under the coffee
outlet.)
If the lock/unlock function is activated, the CHEF card must be inserted into the card
reader in order to switch the coffee machine on and off.
4.4.2. Prepare coffee product
If your coffee machine has a payment system installed and enabled, please read the
instructions in chapter 6.0.
Coffee and hot water are available simultaneously.
Pressing the [
] key deselects the pre-selected product (only if payment is dis-
abled).
Holding down the [
] key for more than two seconds interrupts all of the currently
active products (coffee products only during the infusion phase).
1. Place cup under the coffee outlet (the height of the outlet can be adjusted to the cup).
Danger!
Do not adjust the height of the outlet when the coffee outlet is dispensing
(danger of scalding)!
2. Press the desired product key
3. The LED of the selected key lights up red and the following message is displayed:
<<Standby>>
12:00 15.10.2001
select product
choice 1 supply 1
selection locked
heating up
select product
12:00 15.10.2001
ª
To Next Page
Loading...
Need help?
General
