Siemens LOGO! 24 User Manual

LOGO! Manual
A5E00067781 01
74
Parameter inputs
There some inputs at which you do not apply signals.
Instead, you parameterize the function block with certain
values.
 Par (parameter):
This input is not wired. Here you set parameters for the
block.
 T (time):
This input is not wired. Here you set times for a block.
 No (number):
This input is not wired. Here you set time bases.
 P (priority):
This input is not wired. Here you set priorities.
4.3.2 Time Response
Parameter T
With some of the special functions it is possible to parame-
terize a time value T. When specifying the time, note that
the values to be entered depend on the time base set:
Time Base _ _ : _ _
s (seconds) Seconds :
1
/
100
seconds
m (minutes) Minutes : Seconds
h (hours) Hours : Minutes
B01:T
T=04.10h+
Setting the time T for 250 minutes:
Unit hours (h):
04.00 hours 240 minutes
00.10 hours +10 minutes
= 250 minutes
LOGO! Functions

Siemens LOGO! 24 Specifications

General

Brand	Siemens
Model	LOGO! 24
Category	Controller
Language	English