Prepare and backup project
7.4 Other transfer functions
TP 270, OP 270, MP 270B (WinCC flexible)
7-22 Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0
Result
The authorization is transferred to the HMI device. The option as to which authorization is
required can now be defined on the HMI device.
Procedure - transferring authorization back from the HMI device
Transferring an option back from the HMI device:
1. Start WinCC flexible via the Windows Start menu on the configuration computer and
open a project, or start ProSave via the Windows Start menu.
2. In WinCC flexible, select the menu options "Project > Transfer > Transfer Settings" or
select the HMI device available on the "General" tab in ProSave.
3. Select the connection.
4. Enter the connection parameters.
5. Select the menu options "Project > Transfer > Authorizations" in WinCC flexible or
select the "Authorize" tab in ProSave.
6. Configure the necessary transfer channel on the HMI device.
7. Switch the HMI device to transfer mode.
8. Press the "Device Status" button on the configuration computer to display all the
authorizations currently installed on the HMI device.
9. Select the authorizations under "Installed Authorizations" to be transferred from the HMI
device.
10. Press the "<<" button to start transferring the authorizations back.
Result
The authorization is transferred back from the HMI device. The option as to which
authorization is required can no longer be used on the HMI device.
7.4.5 Transferring options
Introduction
Options specially developed for the HMI device, e.g. additional applications, can be installed
on the HMI device.
ProSave is supplied with the following options by default:
• Drivers for uninterruptible power supply
• Pocket Internet Explorer
To Next Page
Loading...
Need help?
General
