Operate project
9.2 Controlling graphic objects
TP 270, OP 270, MP 270B (WinCC flexible)
Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0
9-55
9.2.20 Sm@rtClient view
9.2.20.1 Description
Purpose
The Sm@rtClient view may be used to start remote monitoring and control of another HMI
device.
With an appropriate configuration, the Sm@rtClient view can be used to monitor and control
a system process from multiple HMI devices with the same authorizations.
Layout
The Sm@rtClient view displays the current Runtime screen of the remote device on your
HMI device. You can now monitor and control this screen according to your configuration.
Scroll bars are displayed if the screen of the remote HMI device is larger than that of your
HMI device.
Behavior
Start
The initiation of remote monitoring or control can be configured in different ways. Depending
on the project, you can view the Runtime of the remote HMI device in the following ways:
• Automatically when the device is started (and selection of the screen with the
Sm@rtClient view if this is not the start screen)
• By activating the Sm@rtClient view with the <Tab> key or by touch on a touch screen
device
• By entering the IP address of the remote HMI device and, if required, entering a
password in the appropriate field in the Sm@rtClient view
To Next Page
Loading...
Need help?
General
