Overview
1.7 Options
TP 270, OP 270, MP 270B (WinCC flexible)
Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0
1-15
Remove memory card
Caution
Ensure that the HMI device does not access the memory card during the removal process.
Otherwise, the contents of the memory card will be fully destroyed.
1. Terminate access made by the HMI device to the memory card.
If the configuration engineer has defined an operating element linked to the
"CloseAllLogs" system function, press the element. Otherwise, press the operating
element linked to the "StopRuntime" system function in the configuration. This ends
runtime.
2. Wait unit the HMI device displays the loader.
Changeover to the loader may take several minutes depending on the size and number
of logs stored.
3. Remove the memory card.
Switch off the HMI device with memory card inserted
Caution
Always terminate the runtime software before switching off the voltage supply in order to
prevent loss of data.
1. Terminate runtime.
Press the operating element linked to the "StopRuntime" system function in the
configuration.
2. Wait unit the HMI device displays the loader.
Changeover to the loader may take several minutes depending on the size and number
of logs stored.
3. Switch off the power supply.
If the power supply is interrupted during normal operation, the HMI device checks the
memory card after power is restored and repairs any defect sectors.
See also
HMI device loader (Page 6-1)
To Next Page
Loading...
Need help?
General
