Siemens SIMATIC TP 270 User Manual

Installation and connection
4.2 Installation of the HMI device
TP 270, OP 270, MP 270B (WinCC flexible)
4-4 Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0
3. Insert the hooks of the spring terminals into the corresponding recesses in the housing of
the HMI device.
The individual positions are indicated in the figures below by means of arrows.
MP 270B 10" Touch,
TP 270 10”
1
MP 270B 6" Touch,
TP 270 6”
1
1 Front panel
4. Working from the back, secure the MP 270B 10" Touch or TP 270 10" in the front panel
using an Allen wrench. Use a Phillips screwdriver for the MP 270B 6" Touch and TP 270
6".
Caution
Check the fit of the rubber seal on the front side. It must not protrude from the HMI
device.
Over tightening the screws will damage the HMI device.
See also
MP 270B 10" Touch, TP 270 10" dimensions (Page 12-1)
MP 270B 6" Touch, TP 270 6" dimensions (Page 12-2)

Siemens SIMATIC TP 270 Specifications

General

Brand	Siemens
Model	SIMATIC TP 270
Category	Touch Panel
Language	English