3.5 Note on the ErP directive
ZIEHL-ABEGG SE wishes to point out that, based on the directive (EU) no. 327/2011 of the Commis-
sion of 30th of March 2011 for enforcing directive 2009/125/EC (hereinafter referred to as ErP
directive), the operational area of certain fans within the EU is bound by certain prerequisites.
The fan may only be used within the EU when it meets the requirements of the ErP directive.
If the said fan does not have a CE mark (cf. especially the rating plate), use of this product within the
EU is not admissible.
All ErP-relevant information comprises measurements which are determined using a standardised
measurement set-up. More details can be obtained from the manufacturer.
Further information about the ErP directive (Energy related Products-Directive) can be found on
www.ziehl-abegg.de
search key: "ErP".
3.6 Transport, storage
Attention!
•
Observe the weight specifications (
rating plate) and the permissible carrying loads of the means
of transport.
•
Wear safety shoes and gloves for handling!
•
Transport the fan(s) either in the original packaging or, in the case of larger fans, on the dedicated
transportation fixtures.
– axial fans: holes drilled in support arms, wall ring plates and motor block
– centrifugal fans depending on type: holes drilled in the housing flange, motor block, fastening
brackets and support plates,
•
Do not transport the fan by the connecting cable!
•
Avoid shocks and impacts to the device during the transport.
•
Avoid extreme humidity, heat or exposure to cold (
Technical Data).
•
Watch out for possible damage to the packaging or fan.
•
Radial impellers, fans with scroll RG.., RD.. or built-in fans type ER../GR.. are generally delivered
on europallets, and can be transported using lift trucks.
•
Fix pallets during transport.
•
Do not stack pallets.
•
Only handle with suitable hoisting gear.
•
Design RG.. / RD.. / ER.. / GR.. : Fan unit may only be lifted and transported when using a suitable
hoisting device (load spreader). Ensure sufficient cable or chain length.
•
Position the lifting beam transversely to the motor axis. Pay attention to adequate width of the lifting
beam.
•
Never stand underneath the suspended fan because defective transport equipment could cause
death.
•
Store the fan / motor in the original packaging in a dry area protected from the weather and protect it
from dirt and weather until final installation.
•
Avoid prolonged storage; we recommend a maximum of one year (consult the manufacturer before
starting if stored for longer).
•
Inspect the bearing for proper operation prior to installation.
– Recommendation: Turn the impeller evenly by hand to avoid jamming and damaging the bearing.
3.7 Disposal / recycling
Disposal must be carried out professionally and in an environmentally friendly way in accordance with
the respective national legal stipulations.
" Separate the materials by type and in an environmentally friendly way.
" If necessary, commission a specialist company with the waste disposal.
Assembly instructions ECblue Product overview
L-BAL-F065-GB 1617 Index 004 Part.-No. 00702801-GB
10/28
To Next Page
Loading...
Need help?
General