EasyManuals Logo
Home>Siemens>Engine>SIMOTICS M-1PH8

Siemens SIMOTICS M-1PH8 User Manual

Siemens SIMOTICS M-1PH8
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
4.13 Transport and storage
When carrying out any work on the machine, observe the general safety instructions
(Page 13) and the specifications contained in EN 50110‑1 regarding safe operation of electrical
equipment.
4.13.1 Checking the delivery
Checking the delivery for completeness
The drive systems are put together on an individual basis. When you take receipt of the
delivery, please check immediately whether the items delivered are in accordance with the
accompanying documents. Siemens will not accept any claims relating to items missing from
the delivery and which are submitted at a later date.
Report any apparent transport damage to the delivery agent immediately. Never
commission a damaged motor.
Report any apparent defects/missing components to the appropriate Siemens office
immediately.
These safety instructions are part of the scope of supply; keep them in a location where they
can be easily accessed.
4.13.2 Lifting and transportation
To safely lift and transport the machine, the following requirements must be met:
Personnel operating cranes and fork-lift trucks must be appropriately qualified.
If the motor is packed, depending on the weight, size and on-site conditions, lift crates and
transport frames using a fork-lift truck or a crane with slings. Use a crane or fork-lift truck
suitable for the load.
When lifting the machine, use only approved and undamaged sling guides and spreaders
of sufficient rated capacity. Check the lifting equipment prior to its use. The weight of the
machine is shown on the rating plate.
When lifting the machine, refer to the information on the lifting plate.
Comply with the specified spreading angles.
Do not exceed the maximum lifting acceleration and lifting speed specified on the lifting
plate. Lift the machine without jerking it.
Acceleration a ≤ 0.4 g (≈ 4 m/s
2
)
Velocity v ≤ 20 m/min
Use only the load carrying device on the stator frame for lifting.
Preparations for use
4.13 Transport and storage
SIMOTICS M-1PH8 1PH818., 1PH822.
36 Operating Instructions 07/2016

Table of Contents

Other manuals for Siemens SIMOTICS M-1PH8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMOTICS M-1PH8 and is the answer not in the manual?

Siemens SIMOTICS M-1PH8 Specifications

General IconGeneral
BrandSiemens
ModelSIMOTICS M-1PH8
CategoryEngine
LanguageEnglish

Related product manuals