5. PARAMETERS
5 - 9
5.1.5 I/O Extension setting 2 parameters ([Pr. PE_ _ ])
Fully closed loop function selection 1
Do not change this value.
Fully closed loop function selection 2
Do not change this value.
Fully closed loop control - Feedback pulse electronic gear 1 – Numerator
Do not change this value.
Fully closed loop control - Feedback pulse electronic gear 1 –
Denominator Do not change this value.
Fully closed loop control - Speed deviation error detection level
Do not change this value.
Fully closed loop control - Position deviation error detection level
Do not change this value.
Fully closed loop dual feedback filter Do not change this value.
Fully closed loop function selection 3 Do not change this value.
Fully closed loop control - Feedback pulse electronic gear 2 – Numerator
Do not change this value.
Fully closed loop control - Feedback pulse electronic gear 2 –
Denominator Do not change this value.
Lost motion compensation positive-side compensation value selection
Lost motion compensation negative-side compensation value selection
Lost motion filter setting
Lost motion compensation function selection
To Next Page
Loading...
Need help?
General
