6
EN
ATYSt - 541995C - SOCOMEC
1. GENERAL SAFETY INSTRUCTIONS
• This manual provides instructions on safety, connections and operation of the ATySt motorised changeover switch
manufactured by SOCOMEC.
• Whether the ATySt is sold as a loose product, as a spare, as an enclosed solution or as any other conguration,
this device must always be installed and commissioned by qualied and experienced personnel, in line with the
manufacturers recommendations, following good engineering practices and after having read and understood the
details in the latest release of the relative product instruction manual.
• Maintenance on the product and any other associated equipment including but not limited to servicing operations must
be performed by adequately trained and qualied personnel.
• Each product is shipped with a label or other form of marking including rating and other important specic product
information. One must also refer to and respect markings on the product prior to installation and commissioning for
values and limits specic to that product.
• Using the product outside the intended scope, outside SOCOMEC recommendations or outside the specied ratings
and limits can cause personal injury and/or damage to equipment.
• This instruction manual must be made accessible so as to be easily available to anyone who may need to read it in
relation with the ATySt.
• The ATySt meets the European Directives governing this type of product and includes CE marking on each product.
• No covers on the ATySt should be opened (with or without voltage) as there may still be dangerous voltages inside the
product such as those from external circuits.
• DonothandleanycontrolorpowercablesconnectedtotheATyStwhenvoltagemaybepresentonthe
productdirectlythroughthemainsorindirectlythroughexternalcircuits.
• Voltages associated with this product may cause injury, electric shock, burns or death. Prior to carry out any
maintenance or other work on live parts or other parts in the vicinity of exposed live parts, ensure that the switch
including all control and associated circuits are de-energized.
DANGER WARNING CAUTION
RISK:
Electric shock, burns, death
RISK:
Possible personal injury
RISK:
Equipment damage
• As a minimum the ATySt comply with the following international standards:
- IEC 60947-6-1
- GB 14048-11
- EN 60947-6-1
- VDE 0660-107
- BS EN 60947-6-1
- NBN EN 60947-6-1
- IEC 60947-3
- IS 13947-3
- EN 60947-3
- NBN EN 60947-3
- BS EN 60947-3
The information provided in this instruction manual is subject to change without notice, remains for general information
only and is non-contractual.
To Next Page
General
