perform fine adjustments of the color tones as required.
In [C.Temp./Filter], you can use the right button to display the color temperature setting
screen and perform a setting. When you press the right button again, the fine adjustment
screen appears to allow you perform fine adjustments as required.
Note
[White Balance] is fixed to [Auto] in the following situations:
[Intelligent Auto]
[Superior Auto]
[Scene Selection]
[120] How to Use Using shooting functions Adjusting color tones
Capturing a basic white color in [Custom Setup] mode
In a scene where the ambient light consists of multiple types of light sources, it is
recommended to use the custom white balance in order to accurately reproduce the
whiteness.
1. MENU → (Camera Settings) → [White Balance] → [Custom Setup].
2. Hold the product so that the white area fully covers the AF area located in the center,
and then press on the center of the control wheel.
The calibrated values (Color Temperature and Color Filter) are displayed.
3. Select a registration number using the right/left button.
The monitor returns to the recording information display while retaining the memorized
custom white balance setting.
Note
The message [Custom WB Error] indicates that the value is higher than the expected
range, when the flash is used on a subject with too bright colors in the frame. If you
register this value, the indicator turns orange on the recording information display.
You can shoot at this point, but it is recommended that you set the white balance again to
get a more accurate white balance value.
[121] How to Use
Using shooting functions Selecting an effect mode
Picture Effect
To Next Page
Loading...
Need help?
General
