Sony A6300 User Manual

Cleaning the image sensor (Cleaning Mode)
Allows you to clean the image sensor.
1. Confirm that the battery has been charged sufficiently.
2. MENU → (Setup) → [Cleaning Mode] → [Enter]
3. Turn off the product following the instructions on the screen.
4. Detach the lens.
5. Use the blower to clean the image sensor surface and the surrounding area.
6. Attach the lens.
Note
A blower is not supplied with this product. Use a commercially available blower.
Cleaning can be performed only when the battery level is (3 remaining battery
icons) or more. The use of an AC-PW20 AC Adaptor is recommended.
Do not use a spray type blower as it may scatter water droplets inside the camera body.
Do not put the tip of a blower into the cavity beyond the lens mount area, so that the tip of
the blower does not touch the image sensor.
Hold the camera slightly face downward so that the dust falls out.
Do not subject the product to any shock during cleaning.
When cleaning the image sensor with a blower, do not blow too hard. If you blow the
sensor too hard, the inside of the product may be damaged.
If the dust remains even after you cleaned the product as described, consult the service
facility.
[208] How to Use
Changing settings Setup menu
Demo Mode

Sony A6300 Specifications

General

ISO Range	100 - 25600 (expandable to 51200)
Continuous Shooting Speed	11 fps
Connectivity	Wi-Fi, NFC
Battery	NP-FW50
Shutter Speed	1/4000 to 30 sec
Built-in Flash	Yes
Dimensions	120.0 x 66.9 x 48.8 mm
Sensor	APS-C Exmor CMOS Sensor
Autofocus Points	425 phase-detection points
Video Resolution	4K UHD (3840 x 2160)
Viewfinder	2.36 million-dot XGA OLED Tru-Finder EVF
Screen	3.0-inch 921k-dot tilting LCD
Battery Life	350 shots (CIPA)
Weight	404g (body only)