of the filter and improper attachment of the hood, the filter or the hood may partially
appear in the image. The optical properties of some lenses may cause the periphery of
the image to appear too dark (insufficient light). You may compensate for this
phenomenon with [Shading Comp.].
[335] Troubleshooting Troubleshooting Shooting still images/movies
The color tones of the image displayed on the
monitor/the viewfinder look unnatural.
[Gamma Disp. Assist] has been activated. Set [Gamma Disp. Assist] to [Off].
[Gamma Disp. Assist] is not working properly. The [Picture Profile] settings are cancelled
when you select other than [Off] for [Picture Effect] or when you use [ Silent
Shooting], even if [Gamma] is set to [S-Log2] or [S-Log3]. Therefore, the color tones are
not displayed correctly when [Gamma Disp. Assist] is set to [Auto]. To display the color
tones properly, set [Gamma Disp. Assist] to [Off].
[336] Troubleshooting Troubleshooting Shooting still images/movies
The image is blurred.
Make sure that [SteadyShot] is set to [On].
The picture was taken in a dark location without the flash, resulting in camera-shake. The
use of a tripod or the flash is recommended. [Hand-held Twilight] and [Anti Motion Blur] in
[Scene Selection] are also effective in reducing blur.
[337] Troubleshooting Troubleshooting Shooting still images/movies
The monitor darkens after a short period of time passed.
If you do not operate the product for a certain period of time, the product switches to the
power-save mode. The product exits power-save mode when you perform operations
such as pressing the shutter button halfway.
To Next Page
Loading...
Need help?
General
