the new time code consecutively from the last time code. The time code advances in [Rec
Run] mode regardless of the [TC Run] setting.
[210] How to Use Changing settings Setup menu
Remote Ctrl
You can shoot images using the RMT-DSLR1 or RMT-DSLR2 remote commanders (sold
separately). Refer also to the operating instructions for the remote commander.
1. MENU → (Setup) → [Remote Ctrl] → desired setting.
Menu item details
On:
Allows remote commander operation.
Off:
Does not allow remote commander operation.
Note
The RMT-DSLR1 remote commander cannot be used for movie recording.
The lens or lens hood may block the remote sensor that receive the signals. Use the
remote commander in the position from which the signal can reach the product.
When [Remote Ctrl] is set to [On], the product does not switch to power save mode. Set
[Remote Ctrl] to [Off] after using a remote commander.
[211] How to Use
Changing settings Setup menu
HDMI Resolution
When you connect the product to a High Definition (HD) TV with HDMI terminals using an
HDMI cable (sold separately), you can select HDMI Resolution to output images to the TV.
1. MENU → (Setup) → [HDMI Settings] → [HDMI Resolution] → desired setting.
Menu item details
Auto:
The product automatically recognizes an HD TV and sets the output resolution.
To Next Page
Loading...
Need help?
General
