it is recommended that you use a tripod.
The longer the exposure time, the more noise will be visible on the image.
After shooting, noise reduction will be done for the same amount of time that the shutter
was open. However, you cannot shoot any more while noise reduction is in progress.
You cannot set the shutter speed to [BULB] in the following situations:
When the [Smile Shutter] function is activated.
When the [Auto HDR] function is activated.
When [Picture Effect] is set to [HDR Painting] or [Rich-tone Mono.].
When the [Multi Frame NR] function is activated.
When the [Drive Mode] function is set to the following modes:
[Cont. Shooting]
[Self-timer(Cont)]
[Cont. Bracket]
[ Silent Shooting]
If you use the above functions when the shutter speed is set to [BULB], the shutter speed
is temporarily set to 30 seconds.
Hint
Images shot in [BULB] mode tend to be blurry. We recommend that you use a tripod or a
remote commander (sold separately) that has a shutter button lock function.
[43] How to Use
Shooting Selecting a shooting mode
Memory recall
Allows you to shoot an image after recalling often-used modes or camera settings registered
in advance.
1. Set the mode dial to 1 or 2 (Memory recall).
2. Press on the center of the control wheel.
You can also recall registered modes or settings by selecting MENU →
(Camera Settings) → [Memory recall].
Hint
To recall settings registered to the memory card, set the mode dial to 1 or 2, then select
the desired number by pressing the left/right side of the control wheel.
Note
Register shooting settings in advance by [Memory].
If you set [Memory recall] after completing the shooting settings, the registered settings
To Next Page
Loading...
Need help?
General
