166
Register Operations in the Menus
Chapter 11 Keyframes
Attaching a name to an effect register
1
Open the Effect >Effect 1-99 >Rename menu (6227).
2
Press the region display in the upper part of the list,
and in the selection window select the region.
You can select more than one region.
To select all regions, press [ALL].
3
Press [OK].
4
Select a register.
5
Press [Rename].
6
Enter a name of not more than 8 characters, and press
[Enter].
The following names cannot be used:
CON, PRN, AUX, CLOCK$, NUL, COM0, COM1,
COM2, COM3, COM4, COM5, COM6,
COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7,
LPT8, LPT9
Displaying a List of Effect Registers
for Editing
You can display a list of effect registers including status
information (whether data is present and so on), then carry
out lock, copy, delete, and rename operations.
Displaying the list of effect registers with
status information
Press the menu title button at the top left of the Effect
menu.
The Effect >Status menu (6200) appears.
The status area shows a list of effect registers (1 to 99).
Register name display
For the same number, the register name for the M/E-1
region takes precedence.
If there is no data for the M/E-1 region, then the register
name appears in the sequence P/P > User 1 to 8 > Device
1 to 12 > P-Bus > GPI > Macro.
Indication colors
Each register has a color-coded border, indicating its
status.
Selected register: Pale blue border
Register containing data: Orange inner border. If,
however, there are one or more locked regions, the
display is in red.
Write-protecting the contents of the
register (lock function)
(This applies to all regions.)
1
In the Effect >Status menu (6200), select the register.
2
Press [Lock].
The register is locked, and the background of the
register indication appears in red.
To release the lock
Press [Lock] once more, turning the contents of the frame
to orange.
Copying the contents of a register
(This applies to all regions.)
1
In the Effect >Status menu (6200), select the copy
source register.
2
In the <Copy> group, press [From __ ].
3
Select the copy destination register.
4
In the <Copy> group, press [To __ ].
Deleting the contents of a register
(This applies to all regions.)
1
In the Effect >Status menu (6200), select the register.
2
Press [Delete].
Renaming a register
(This applies to all regions.)
1
In the Effect >Status menu (6200), select the register.
2
Press [Rename].
3
Enter a name of not more than 8 characters, and press
[Enter].
Notes
To Next Page
Loading...
Need help?
General