222
Overall Control Panel Settings
Chapter 17 Control Panel Setup
4
Select the function you want to assign from the list on
the right.
5
Press [Set].
To cancel the assignment
Press [Clear].
To make the assignment the default
Press [Default].
Assigning Devices or Functions to
the Region Selection Buttons of the
Device Control Block (Trackball)
1
Open the Engineering Setup >Panel >Config
>Trackball Module menu (7321.17).
2
In the button indications on the left, press the button
for the assignment.
3
Select the device or function to be assigned.
4
Press [Set].
To cancel an assignment
Select the button, then press [Clear].
To return all button assignments to the factory
default state
Press [Default].
Inhibiting Utility Bus and Key
Operations
You can inhibit operations on the utility bus and keys of
the M/E and PGM/PST banks from the menu.
This inhibition applies to the following control blocks.
• Cross-point control block
• Transition control block
1
Open the Engineering Setup >Panel >Config >Util
Bus/Key Inhibit menu (7321.18).
2
In the list in the status area, select the switcher bank for
which operations are to be inhibited.
3
In the <Util Bus/Key Inhibit> group, press the utility
bus or key button ([Util1 Bus] or [Key1] to [Key4]) for
the operations to be inhibited.
Assigning Functions to the Buttons
in the Flexi Pad
You can assign functions to the buttons in the various parts
of the Flexi Pad in the following menus.
Mode selection buttons: Multi Function Module menu
Region selection buttons: Region Button Assign menu
Memory recall buttons: Multi Function Module menu
For details about assignment of regions to the region
selection buttons, 1 “Assigning Regions to Region
Selection Buttons in the Flexi Pad” (p. 220).
1
Open the Engineering Setup >Panel >Config >Multi
Function Module menu (7321.20).
2
Press one of the following three buttons displayed in
the button area.
[Mode Sel Assign] button: Assigns a function to the
mode selection buttons
[Eff Edit Assign] button: Assigns a function to a
button in the memory recall section for effect
editing (when the [EFF] and [EDIT ENBL]
buttons are pressed)
[Macro Edit Assign] button: Assigns a function to a
button in the memory recall section for macro
editing (when the [MCRO] and [EDIT ENBL]
buttons are pressed)
3
In the button indications on the left, press the button
for the assignment.
4
Select the mode or action to be assigned.
The following modes and functions can be selected.
• Mode selection buttons
• Buttons in the memory recall section during
effect editing
Mode Button indication
Effect EFF
Snapshot SNAP SHOT
Shotbox SHOTBOX
Macro MCRO
Wipe snapshot WIPE
DME wipe snapshot DME WIPE
Transition rate TRANS RATE
Key adjust KEY ADJ
Key snapshot KEY SS
Function Button indication
Undo UNDO
Pause setting PAUS
To Next Page
Loading...
Need help?
General