24
Names and Functions of Parts of the Control Panel
Chapter 2 Names and Functions of Parts
Transition Control Block
In the transition control block, you can modify the output
of the M/E bank or PGM/PST bank, and perform
transitions. Both common transition and independent key
transition operations are possible.
a Next transition selection buttons
These specify how the image will be changed as a result of
the next transition.
b Transition type selection buttons
These select the transition type (1 p. 47).
When multi-program mode is selected in the Setup menu,
two or more of the following buttons may light.
For details about the multi-program mode setting,
1 “Setting the Operation Mode” (p. 240).
You can also assign a function to these buttons that selects
whether or not the fader levers are used as keyframe
faders.
For details, 1 “Executing an effect manually” (p. 161).
6 PRIOR SET button
1 Next transition selection buttons
7 Key priority display
2 Transition type selection buttons
3 Transition execution
section
4 Wipe direction selection buttons
8 Independent key transition
execution section
q; Independent key transition type selection buttons
9 Key delegation buttons
5 TRANS PVW button
qs K-SS STORE button
Shown above is the right-hand type transition control
block (with the right-hand fader lever).
qa Key snapshot
buttons
Name Description
BKGD
(background)
The next transition will change the
background.
KEY1 to KEY4
(DSK1 to DSK4
for the PGM/PST
bank)
• Press a button, turning it on, to make
the next transition insert or remove the
corresponding key (keys 1 to 4).
• If the key is currently not inserted, the
transition will insert it, and if the key is
currently inserted, the transition will
delete it.
KEY PRIOR
(priority)
The priority setting of the key after the
next transition is enabled.
ALL This turns on a preselected set of the
[BKGD], [KEY1] to [KEY4], and [KEY
PRIOR] buttons. Make this setting in the
Setup menu.
Name Description
To Next Page
Loading...
Need help?
General