Sony STR-DN1070 User Manual

The USB device is being connected upside down. Connect the USB device in the correct
orientation.
[262] Troubleshooting
USB devices
Erroneous display.
The data stored in the USB device may have been corrupted.
The character codes that can be displayed by this receiver are as follows:
Upper case letters (A to Z)
Lower case letters (a to z)
Numbers (0 to 9)
Symbols (’ = < > * + , – . / @ [ \ ] _ `)
Other characters may not be displayed correctly.
[263] Troubleshooting
USB devices
An audio file cannot be played.
MP3 files in MP3 PRO format cannot be played.
The audio file is a multiple track audio file.
Some AAC files may not be played correctly.
If you use a partitioned USB device, only audio files on the first partition can be played.
Playback is possible up to 9 levels (including the root folder).
There are more than 500 folders (including the root folder).
There are more than 500 files.
Files that are encrypted, protected by passwords, etc. cannot be played.
[264] Troubleshooting
Network connection
Cannot connect to the network using WPS via a
wireless LAN connection.
You cannot connect to a network using WPS if your access point is set to WEP. Set up your
network after searching the access point using the access point scan.
[265] Troubleshooting
Network connection
Cannot connect to the network.
Check that the LAN cable is connected to the receiver when you want to connect the
receiver to the network via a wired LAN connection.
Check the network information. If the connection failed, set up the network connection
again.
If the receiver is connected through a wireless network, move the receiver and the wireless
LAN router/access point closer to each other and perform the setup again.
Make sure that you use a wireless LAN router/access point.
Make sure that the wireless LAN router/access point is turned on.
Check the settings of the wireless LAN router/access point and perform the setup again.
For details on the settings of devices, refer to the operating instructions of the devices.

Sony STR-DN1070 Specifications

General

Receiver type	Surround
Audio output channels	7.2 channels
Power output per channel (20-20KHz@8 Ohm)	- W
HDMI in	6
Audio (L/R) in	4
Digital audio coaxial in	1
Number of HDMI outputs	2
Connectivity technology	Wired & Wireless
Speakers connectivity type	Banana connector
Ethernet LAN	Yes
Bluetooth version	3.0+HS
Supported radio bands	AM, FM
Preset stations quantity	30
Optical drive included	No
Display	-
Product color	Black
Audio decoders	DTS, DTS 96/24, DTS-ES, DTS-ES (Discrete 6.1), DTS-ES (Matrix 6.1), DTS-HD, Dolby Digital, Dolby Digital EX, Dolby Digital Plus, Dolby Dual Mono, Dolby Pro Logic, Dolby Pro Logic II, Dolby Pro Logic IIx, Dolby TrueHD
Power consumption (standby)	0.4 W
Audio formats supported	AAC, AC3, AIFF, ALAC, FLAC, HE-AAC, LPCM, M4A, MP3, WAV, WMA

Weight and Dimensions

Depth	329.438 mm
Width	430.022 mm
Height	171.958 mm
Weight	10500.663 g