Note
Do not leave the remote control in an extremely hot or humid place.
Do not use a new battery with an old one.
Do not mix manganese batteries with other kinds of batteries.
Do not expose the remote control sensor to direct sunlight or lights. Doing so may cause a
malfunction.
If you do not intend to use the remote control for an extended period of time, remove the batteries to
avoid possible damage from battery leakage and corrosion.
When the receiver no longer responds to the remote control, replace both of the batteries with new
ones.
[40] Preparation 6. Turning on the receiver/preparing the remote control
Turning on the receiver
Before connecting the AC power cord (mains lead), be sure to make connections with speakers
and the other devices.
Note
After you turn off the receiver, [STANDBY] flashes on the display panel. Do not disconnect the AC
power cord (mains lead) while [STANDBY] is flashing. This may cause a malfunction.
[41] Preparation 7. Setting up the receiver using Easy Setup
Connect the AC power cord (mains lead) to a wall outlet.
1
Press (power) to turn on the receiver.
You can also turn on the receiver using (power) on the remote control. To turn off the
receiver, press
(power) again.
2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
