18
No. Device Note
M5x12
L-shaped angle steel
* is optional.
The foregoing components are based on the standard inverter, and those of the
actual product may differ.
4.2 Identifying the Inverter
Identify the inverter via its nameplate. The nameplate contains the following information:
inverter model, major technical parameters, marks of conformitys, origins, and serial number.
Very important technical parameters and inverter-related parameters are displayed
on the nameplate.
Protect the nameplate at all times!
4.3 Checking for Transport Damages
The inverter has been strictly inspected and tested before delivery. Despite robust
packaging, the cabinet or internal devices may be damaged during transport. Therefore,
once receiving the inverter, perform a detailed inspection.
If any damage is found, contact the forwarding company or Sungrow immediately.
• Check the scope of delivery described in "4.1 Scope of Delivery"for completeness.
• Check that the inverter and inner devices match the models included in the original order.
• Check thoroughly the inverter and inner devices for any possible damages caused
during transport.
Install and commission the inverter only when it is technically faultless! Make sure
before installing the inverter that
• the inverter is intact without any damage; and
• all devices inside the inverter are intact without any damages.
4.4 Storage of the Inverter
If the inverter is not to be installed immediately after delivery, store it appropriately:
4 Delivery System Manual
To Next Page
Loading...
