9-68 CHASSIS
RUBBER PARTS
Inspect the rubber parts for damage. If any damage is found,
replace them with the new ones.
CALIPER REASSEMBLY AND REMOUNTING
Reassemble the caliper in the reverse order of removal and dis-
assembly. Pay attention to the following points:
• Wash the caliper bores and pistons with specified brake fluid.
Particularly wash the dust seal groove and piston seal groove.
N Specification and Classification: DOT 4

PISTON SEAL
• Install the piston seal and dust seal as shown in the illustra-
tion.
• Install the piston to the caliper.
* Wash the caliper components with fresh brake fluid
before reassembly. Never use cleaning solvent or gaso-
line to wash them.
* Do not wipe the brake fluid off after washing the compo-
nents with a rag.
* When washing the components, use the specified brake
fluid. Never use different types of fluid or cleaning sol-
vent such as gasoline, kerosine or the others.
* Replace the piston seals and dust seals with the new
ones when reassembly.
* Apply the brake fluid to both seals when installing them.
To Next Page
Loading...
Need help?
General
