ELECTRICAL SYSTEM 10-37
BATTERY
SPECIFICATIONS
a Anode plates
e Stopper
b Separator (fiberglass plate)
f Filter
c Cathode plates
g Terminal
d Upper cover breather
h Safty valve
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape
1 which seals the battery filler
holes
2.
• Remove the caps
3 from the electrolyte container.
NOTE:
* Do not remove or pierce the sealed areas
4 of the electrolyte
container.
* After completely filling the battery with electrolyte, use the caps
3 from the electrolyte container to seal the battery filler holes.
• Insert the nozzles of the electrolyte container
5
into the elec-
trolyte filler holes of the battery. Hold the electrolyte container
firmly so that it does not fall. Do not allow any of the electro-
lyte to spill.
• Make sure the air bubbles
1 rise to the top of each electrolyte
container and leave the electrolyte container in this position
for more than 20 minutes.
Type designation FTX14-BS
Capacity 12V, 43.2 kC (12 Ah)/10HR
To Next Page
Loading...
Need help?
General
