CHASSIS 9-71
• Pull out the dust boot
4 and remove the snap ring
5.
• Remove the piston and return spring.
6 Piston
7 Secondary cup
8 Primary cup
9 Return spring
MASTER CYLINDER INSPECTION
Inspect the master cylinder bore for any scratches or other dam-
age.
Inspect the piston surface for any scratches or other damage.
Inspect the primary cup, secondary cup and dust boot for wear
or damage.
If any defects are found, replace them with new ones.
MASTER CYLINDER REASSEMBLY AND
REMOUNTING
Reassemble the master cylinder in the reverse order of removal
and disassembly. Pay attention to the following points:

N Specification and Classification: DOT 4
* Wash the master cylinder components with fresh
brake fluid before reassembly. Never use cleaning
solvent or gasoline to wash them.
* Do not wipe the components with a rag.
* Apply brake fluid to the cylinder bore and all the
component to be inserted into the bore.
To Next Page
Loading...
Need help?
General
