CHASSIS 9-73
REAR BRAKE
CONSTRUCTION
"

* This brake system is filled with an ethylene glycol-based DOT 4 brake fluid. Do not use or mix dif-
ferent types of fluid such as silicone-based or petroleum-based.
* Do not use any brake fluid taken from old, used or unsealed containers. Never reuse brake fluid
left over from the last servicing or stored for long periods.
* When storing the brake fluid, seal the container completely and keep away from children.
* When replenishing brake fluid, take care not to get dust into fluid.
* When washing brake components, use fresh brake fluid. Never use cleaning solvent.
* A contaminated brake disc or brake pad reduces braking performance. Discard contaminated pads
and clean the disc with high quality brake cleaner or neutral detergent.
Handle brake fluid with care: the fluid reacts chemically with paint, plastics, rubber materials etc.
and will damage them severly.
ITEM N·m kgf-m lb-ft
A
10 1.0 7.0
B
23 2.3 16.5
C
16 1.6 11.5
D
23 2.3 16.5
E
13 1.3 9.5
F
7.5 0.75 5.5
G
23 2.3 16.5
H
9.5 0.95 7.0
I
18 1.8 13.0
@
1
Diaphragm
A
Master cylinder bolt
2
Piston/cup set
B
Brake hose union bolt
3
Master cylinder
C
Brake pipe nut
4
Brake hose No. 1
D
Caliper holder sliding pin
5
Brake pipe
E
Caliper holder sliding pin
6
Brake hose No. 2
F
Air bleeder valve
7
Caliper holder
G
Brake-lock housing bolt
8
Caliper
H
Locknut
9
Gasket
I
Pad mounting pin
0
Brake-lock housing
A
O-ring
B
Brake-lock shaft
C
Brake-lock adjuster
D
Brake-lock arm
E
Pad
F
Piston
G
Dust seal
H
Piston seal
To Next Page
Loading...
Need help?
General
