Tait TM8110 Service Manual

TM8100/TM8200 Service Manual Receiver Fault Finding 253
© Tait Electronics Limited June 2006
10.5 Faulty Radio Mute
Introduction If the radio mute is faulty, the calibration settings are suspect. There are three
tasks:
■ Task 14: determine type of muting selected
■ Task 15: noise muting selected
■ Task 16: RSSI muting selected
The programming application is required for Task 14, and the calibration
application for Task 15 and Task 16.
Task 14 —
Determine Type of
Muting Selected
First use the programming application to determine the type of muting
selected.
1. In the programming application click the “Basic Settings” page under
the “Networks” heading.
2. Click the “Basic Network Settings” tab.
3. Check the setting in the “Squelch Detect Type” field. Ensure that the
setting is what the Customer expects.
4. If the setting is “Noise Level”, implying that noise muting is selected,
go to Task 15
. If the setting is “Signal Strength”, implying that RSSI
muting is selected, go to Tas k 16
.

Tait TM8110 Specifications

General

Brand	Tait
Model	TM8110
Category	Radio
Language	English