Saving oscilloscope setup information
You can save the oscilloscope internal settings to an internal memory location
(setup 1–10) or to an external file on the USB drive. A setup file contains most of
the oscilloscope settings, including vertical, horizontal, trigger, cursor, and
measurement parameters. It does not include communications information, such
as GPIB addresses. You can then use the setup data to quickly set the
oscilloscope to take a certain measurement.
Use this procedure to save the current oscilloscope settings to a memory location
or external file.
1. (Optional) Install a USB drive to save the setup data to a file on the USB
drive.
2. Push the Save/Recall front-panel button.
3. Push the Action side-menu button.
4. Use the Multipurpose knob to select and click Save Setup.
5. To save setup data to internal setup memory:
a. Push Save To side-menu button.
b. Select and click Setup.
c. Push Setup side-menu button and use the Multipurpose knob to select
the setup memory location (1-10).
d. Push Save side-menu button.
6. To save setup data to a file on the USB drive:
a. Push Save To side-menu button.
b. Use the Multipurpose knob to select and click USB File (*.SET file).
c. Push Save TEKxxxxx.SET side-menu button to save the setup data to an
automatically named *.SET file at the top level of the USB drive. See
About automatically generated file names on page 146.
Saving data
132 TBS2000B Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
